GReddy Turbo Kit
2003 Infiniti G35 Coupe (VQ35DE) Twin TD05-18G 8cm
2003 Infiniti G35 Coupe (VQ35DE) Twin TD05-18G 8cm
Installation Manual
Please read the entire manual before installing this kit.
Make Model Chassis Year
Infiniti G35 Coupe (6 speed MT) CPV35 2003
∙ This GReddy Turbo Kit is designed only for the vehicles specified above.
∙ GReddy Front mount intercooler kit is recommended with this kit
∙ Premium grade gasoline (91 octane or higher) is required with this Kit.
∙ Make sure that the vehicle is not equipped with any ECU upgrade chips.
∙ Use of GReddy Racing Spark Plugs ISO #7 or NGK plugs (colder than factory) is
recommended with this kit.
Important
1. This installation should only be performed by a trained specialist who is very
familiar with the automobile’s mechanical, electrical and fuel management
2. If installed by an untrained person, it may cause damage to the kit as well as
the vehicle.
3. GReddy Performance Products Inc. is not responsible for any damage to
the vehicle’s electrical system caused by improper installation.
4. Make sure to follow the instruction and pay attention to the “Important”,
“Warning!” and “Caution!” notice through out the instruction.
5. Improper installation can be dangerous! Please make sure to inspect the
installation before operating the vehicle.
6. Call your GReddy Authorized dealer or GReddy Performance Products if
there are any problems or questions regarding this product.
2. Factory Parts Removal When removing the stock parts, make sure you read over the factory repair manual for proper procedures. 2-1 Disconnect the negative terminal of the battery. 2-2 Drain the engine oil, coolant and power steering fluid. 2-3 Disconnect the air flow meter. 2-4 Remove the Air cleaner assembly with airflow meter, intake tube, and breather hose. 2-5 Remove the Top Radiator Hose and the Water Pipe (Located above the Right Exhaust manifold). 2-5 Disconnect the primary and secondary O2 sensor and remove the exhaust manifold and catalytic converter. 2-6 Remove the exhaust manifold. 2-7 Remove oil pan (Please refer to the factory service manual for detail instructions f or removing the oil pan.) 2-8 Remove the upper intake manifold collector, fuel rail assembly with injectors and regulator.
Get The File | Download here | PDF Manual
2. Factory Parts Removal When removing the stock parts, make sure you read over the factory repair manual for proper procedures. 2-1 Disconnect the negative terminal of the battery. 2-2 Drain the engine oil, coolant and power steering fluid. 2-3 Disconnect the air flow meter. 2-4 Remove the Air cleaner assembly with airflow meter, intake tube, and breather hose. 2-5 Remove the Top Radiator Hose and the Water Pipe (Located above the Right Exhaust manifold). 2-5 Disconnect the primary and secondary O2 sensor and remove the exhaust manifold and catalytic converter. 2-6 Remove the exhaust manifold. 2-7 Remove oil pan (Please refer to the factory service manual for detail instructions f or removing the oil pan.) 2-8 Remove the upper intake manifold collector, fuel rail assembly with injectors and regulator.
Get The File | Download here | PDF Manual
